Lesson 12 · Execution
Every lesson so far has been about deciding what to trade and how much of it. This one is about the couple of seconds between pressing the button and owning the stock, which is where a surprising amount of a beginner’s money quietly goes.
A market order guarantees you a fill and promises nothing about the price. A limit order guarantees the price and promises nothing about the fill.
The spread is a cost you pay on the way in and again on the way out.
A marketable limit gives you most of the speed of a market order with a ceiling on what you will pay for it.
A stop order and a stop-limit order behave completely differently on the one day it matters.
The bid, the ask, and the money in between
Two numbers sit at the front of every stock. The bid is the highest price anyone is currently willing to pay. The ask, or offer, is the lowest price anyone is currently willing to sell at. You buy at the ask and you sell at the bid, which means the gap between them — the spread — is money you hand over simply for changing your mind.
On a large, heavily traded stock the spread is a penny and you can reasonably ignore it. On the sort of low-priced, low-float name this course is about, it can be four cents, ten cents, or wider in the first minutes of the session. That is not a detail. Set against the thirteen cent stop from Lesson 11, a four cent spread is nearly a third of the risk you budgeted, paid before the trade has done anything at all.
The practical filter is simple. If the spread is a meaningful fraction of the distance to your first target, the trade is worse than the chart makes it look, and the chart will never tell you this. Look at the actual bid and ask before you decide a setup is worth taking.
Market orders: certainty of a fill, and nothing else
A market order says: I want in now, at whatever price exists. It will fill. What it cannot do is tell you the price in advance, and the reason is that there is no single price — there is a queue of offers at rising prices, each with a limited number of shares behind it.
If you send a market order for more shares than are sitting at the best offer, it takes those, then the ones above, then the ones above those. That is called walking the book, and on a fast small cap it is how people end up paying eight cents more than the price they thought they were buying at.
The number underneath the left panel is worth sitting with. On five thousand shares, eight cents of slippage is close to four hundred dollars. That is not a market move you read wrong. That is a cost you chose by using the wrong order type.
A market order on a thin stock is not an entry. It is an offer to pay whatever the book asks.
Limit orders, and the hybrid that solves most of it
A limit order names your worst acceptable price. A limit buy at 10.52 fills at 10.52 or better and never above. What you give up is certainty: if the stock never comes back to your price, you do not get the trade.
That is a real cost, and beginners underrate it, because a missed winner feels free while a bad fill feels like a loss. But it is a bounded cost — you either got the trade or you did not — whereas slippage on a market order has no ceiling and arrives without warning.
The hybrid that solves most of this is a marketable limit order: a limit priced a few cents through the current offer. You are saying take whatever is available up to here, and then stop. It behaves like a market order in normal conditions and refuses to chase in abnormal ones, which is exactly the behaviour you want on a stock that can move ten cents while you are still clicking.
| Market | Limit | Marketable limit | |
|---|---|---|---|
| What is guaranteed | You get filled | You get your price or better | You get your price or better, usually straight away |
| What is not | The price, and there is no limit to how bad it can be | That you get filled at all | That the whole size fills |
| Behaviour in a fast move | Walks the book and pays whatever it finds | Sits there while price runs away | Takes what is there and stops at your ceiling |
| Sensible use | Getting out of a liquid position when the price matters less than being out | Patient entries at a level you marked in advance | Most entries and most exits on a volatile small cap |
Stops: the difference that only shows up on the bad day
Lesson 11 told you to put the stop order in rather than hold it in your head. There are two ways to do that and they are not interchangeable.
A stop order, sometimes called a stop-market, sits inactive until price touches your trigger and then becomes a market order. It gets you out. It does not promise a price, and in a flush it will fill below your trigger.
A stop-limit order becomes a limit order at your trigger instead. It promises a price and not an exit. On a stock falling fast, price can trade straight through your limit and keep going, leaving the order unfilled and you still holding a position that is now considerably worse.
Read the right panel carefully, because it is the one that ends accounts. Your planned loss was thirteen cents, one R. The stop-market fill at 10.28 cost twenty-seven cents, about two R — irritating, survivable, over. The unfilled stop-limit left you long at 10.05, down fifty cents, roughly four R, with no exit and nothing resembling a plan.
For a protective exit on a volatile small cap, take the stop-market. The slippage is the premium you pay for certainty of exit, and Lesson 11 already told you to size so that a slightly worse fill than planned is still an ordinary loss. Stop-limits have genuine uses, but protecting you from a fast move is not one of them.
A trailing stop follows price by a fixed amount or percentage and only ever moves in your favour. It sounds ideal and works poorly on the stocks in this course, because ordinary small-cap noise is wide enough to trigger any trail tight enough to protect a profit. If you want to lock in a gain, moving a stop deliberately to a level that means something beats letting a percentage do it for you.
Two order pairs are worth knowing by name. An OCO — one cancels other — holds your target and your stop together, so filling either one cancels the other. That prevents the specific horror of a target filling while a stale stop sits live and quietly opens a short position you never wanted. An OTO — one triggers other — places the protective stop automatically the moment your entry fills, which is the closest thing to a good habit you can hand off to software.
Time in force: how long the order lives
| Instruction | What it does |
|---|---|
| Day | Expires at the close if unfilled. The sane default for everything in this course. |
| GTC | Good till cancelled — survives overnight and for weeks. This is how you find out on Tuesday that you are still holding something from Friday. |
| IOC | Immediate or cancel. Fills whatever it can this instant and cancels the rest. Useful when you want part of a position rather than a queue position. |
| FOK | Fill or kill. All of it right now or none of it. Rarely what a small-cap trader wants, because partial fills are normal. |
| AON | All or none. Waits for the full size to be available. Often means waiting forever on a thin book. |
| MOO / LOO | Market or limit on open. Participates in the opening auction. The open is the most violent part of the day, so a limit version is the only one worth considering. |
| MOC / LOC | Market or limit on close. Participates in the closing auction, with an earlier cut-off than you expect. |
| EXT | Allows premarket and after-hours execution. Almost always must be a limit, because those books are thin enough that a market order in them borders on reckless. |
Two worked examples on fast small caps
The numbers below are made up to show the mechanics. They are not trades from a real account.
Market vs limit order on a fast $3 stock
A $3 stock is running on news. The screen shows bid $3.10, ask $3.14, but only 300 shares are offered at $3.14, then 500 at $3.18 and 1,000 at $3.25.
- Market order for 1,000 shares: fills 300 at $3.14, 500 at $3.18 and 200 at $3.25. Your average is about $3.18, four cents above the price you saw. By the time it reaches the exchange, the ask may already be higher.
- Limit order at $3.15: you get 300 shares at $3.14, then nothing more unless sellers come back down to $3.15. You might end up with a partial position, or none.
Neither is “right”. The market order bought you speed at a cost. The limit order protected your price but may cost you the trade. If you have to chase with a market order, it’s often a sign the entry was late. See FOMO trading.
Stop loss vs stop limit on a $4 stock
You buy 500 shares at $4.20 and decide your stop is $4.00. You planned to risk $0.20 a share, or $100.
Normal day
The stock drifts down: $4.05, $4.02, $4.00. Your stop loss triggers and fills at $3.99 or $4.00. Your stop limit at $4.00 / limit $3.95 also fills. Both lose roughly the $100 you planned.
Bad day
The company announces an offering. The stock drops from $4.10 to $3.60 in a few seconds with almost no trades in between, or it halts and reopens lower.
- Stop loss: triggers and sells at the next bid, say $3.60. You are out, but the loss is $0.60 a share, or $300, three times what you planned.
- Stop limit ($4.00 stop, $3.95 limit): triggers, places a sell order at $3.95, and nobody is buying at $3.95 any more. You are still holding. If the stock keeps sliding to $3.20, your loss is now $500 and growing.
Neither order saved the plan. But the stop loss at least ended the trade. With the stop limit, the worst case has no floor.
Order type mistakes that cost real money
- A market order into a spike. The one moment the book is thinnest is the one moment beginners reach for the order type that ignores price entirely.
- Using a stop-limit as protection. It will work perfectly for months and then fail on the only day you needed it.
- Not looking at the spread. If it is a third of your risk, the setup on the chart is not the trade you are actually getting.
- Leaving a stale order live. An unpaired stop after a target fills does not protect anything. It opens a new position.
- Naming a limit price and then chasing it. Cancelling and replacing three cents higher each time is a market order paid for in instalments.
Putting it together
Before the entry, look at the bid, the ask and the size sitting there, and decide whether the spread leaves the trade worth taking. Enter with a marketable limit a few cents through the offer rather than a market order. Place the protective stop as a stop-market, ideally attached to the entry so it goes in by itself. Pair the target and the stop so one cancels the other. Then leave it alone.
None of that makes a bad setup good. What it does is stop a good setup from being quietly taxed by mechanics you did not think about, which over a few hundred trades is the difference between a method that works on paper and one that works in an account.
The chart tells you what to do. The order type decides how much of it you actually get.
An honest word on risk: a better order type reduces cost, not risk. Most retail day traders lose money overall, and no order type changes that. Nothing here is financial advice, and the order types available to you vary by broker and by country — check what your own account actually supports.
Order types FAQ
What is the difference between a market order and a limit order?
A market order buys or sells right away at the best available price, so it is almost certain to fill but the price is not guaranteed. A limit order sets the worst price you will accept: a buy limit fills only at your price or lower, a sell limit only at your price or higher. The trade-off is that a limit order may fill only partly, or not at all.
What is a stop-limit order?
A stop-limit order has two prices. When the stock reaches the stop price, the order becomes a limit order at your limit price. That gives you price control, but if the stock moves through your limit quickly, the order may not fill at all.
What is the difference between a stop order and a stop-limit order?
Once triggered, a stop order becomes a market order, so it will usually fill but possibly far from the stop price in a fast market. A stop-limit order becomes a limit order, so it protects the price but may never fill. For getting out of a falling position, that difference matters most.
When should I use a limit order?
On thinly traded stocks, in pre-market and after hours, and any time the bid-ask spread is wide. A limit order stops you from paying far more, or selling for far less, than the price you saw.
Why did my stop-limit order not fill?
The price moved past your limit before your order could execute, often on a gap, a fast drop or a reopening after a halt. A triggered stop-limit only fills at your limit price or better.
Sources: Investor.gov, Types of orders; FINRA Regulatory Notice 16-19 on stop and stop-limit orders. Related: the bid-ask spread and trading halts. Checked November 3, 2026.
Keep learning
You now know which order to send. The next lesson follows it out of the door: where your broker routes it, why commission-free is not free, what shorting adds to the picture, and how to read Level 2 without being hypnotised by it.
Related: what the bid-ask spread costs you, and why it’s wider on small caps and pre-market.
Keep a record. Writing down which order type you used on each trade, and the price you got versus the price you wanted, shows where slippage is coming from. The free trading journal template is a simple place to start. If you’d rather import your broker’s CSV and have the reports built for you, there’s also the Greenwick Journal ($49.99 once, runs offline).
Free, by email
Get the journal series in your inbox
All 16 journal lessons in one email, then a short note when a new lesson goes up. Nothing else. Unsubscribe any time.
← Previous: Risk Management — Position Sizing and Stops Next: Order Routing, Level 2 and Execution Costs →